Справочник Пользователя для Canon LV8227M

14

To ensure safe operation, please observe the following precautions :

  ● Use two (2) AAA type batteries.

  ● Always replace batteries in sets.

  ● Do not use a new battery with a used battery.

  ● Avoid contact with water or liquid.

  ● Do not expose the remote control unit to moisture or heat.

  ● Do not drop the remote control unit.

  ●  If the battery has leaked on the remote control unit, carefully wipe the case clean and install new 

batteries.

  ● Risk of an explosion if battery is replaced by an incorrect type. 

  ● Dispose of used batteries according to the instructions or your local disposal rule or guidelines.

Open the battery 

compartment lid.

Install new batteries 

into the compartment.

Replace the 

compartment lid.

For correct polarity 

(+ and –), be sure 

battery terminals are 

in contact with pins in 

compartment.

Point the remote control unit toward the projector 

(Infrared  Remote  Receiver)  when  pressing  the 

buttons. Maximum operating range for the remote 

control unit is about 16.4'(5 m) and 60 degrees in 

front of the projector.

16.4'

(5 m)

30° Remote control unit

30°

The  2  different  remote  control  codes  (Code 

1–Code  2)  are  assigned  to  this  projector. 

Switching  the  remote  control  codes  prevents 

interference from other remote control units when 

several projectors or video equipment next to each 

other are operated at the same time. Change the 

remote  control  code  for  the  projector  first  before 

changing  that  for  the  remote  control  unit.  See 

"Remote control" in the Setting Menu on page 59.

Press  and  hold  the  MENU  and  IMAGE  buttons 

for  more  than  five  seconds  to  switch  between 

the 

Code 1 and Code 2. The initial code is set to 

Code 1.

LV-RC06