Справочник Пользователя для Pitney Bowes DM400c

If you notice incomplete or poor sealing and the moistener tank is 

full, you may need to clean the moistener brush or wick. If the seal 

quality doesn’t improve after cleaning you can replace the stripper 

blade and brush assembly or wick as needed. See Chapter 9,

Supples and Optons for instructions on ordering these supplies for 

your machine.

1.  Push the lever up, on the stripper blade and brush assembly.
2.  Whilst holding the lever up, grasp the assembly and pull it 

straight out towards you.

3.  Clean the moistener brush by running it under plain water.

NOTE:  If the assembly cannot be cleaned throughly, then it 

should be replaced.

4.  If you need to clean the wick and shield, continue with Cleanng

the Sheld and Wck on the next page. Otherwise, push up on the 

release lever on the stripper blade and brush assembly.

5.  Slide the assembly back onto the machine. You should hear a 

click as it engages.