Справочник Пользователя для Canon MP800

*1:  General notes: 

- Make sure that the flexible cables and wires in the harness are in the proper position and connected correctly. 

[See 3-2. Special Notes on Repair Servicing, (3) Flexible cable and harness wiring, connection, for details.]

 

- Do not drop the ferrite core, which may cause damage. 

- Protect electrical parts from damage due to static electricity. 

- Before removing a unit, after removing the power cord, allow the machine to sit for approx. 1 minute (for capacitor 

discharging to protect the logic board ass'y from damages). 

- Do not touch the timing slit strip film and timing slit disk film. No grease or abrasion is allowed. 

- Protect the units from soiled with ink. 

- Protect the housing from scratches. 

- Exercise caution with the red screws, as follows: 

i.  The red screws of the paper feed motor may be loosened only at replacement of the paper feed motor unit (DO 

NOT loosen them in other cases). 

ii.  DO NOT loosen the red screws on both sides of the main chassis, securing the carriage shaft positioning (they are 

not adjustable in servicing) 

   

[See 3.3. Adjustment / Settings, 

(2) Grease application.]

 

Timing slit strip film 
QC1-6526

 

- Upon contact with the film, 

wipe the film with ethanol. 

 

- Confirm no grease is on the 

film. (Wipe off any grease 
thoroughly with ethanol.) 

 

- Do not bend the film

 

After replacement: 

1.  Perform the print head 

alignment in the user mode. 

- Service test print

 

Timing slit disk film

 

QC1-6229

 

Print head 
QY6-0061

 

 

 

 

1.  Perform the print head 

alignment in the user mode.

 

- Service test print

 

1-14