Справочник Пользователя для Canon iPF8400SE

Cause

Corrective Action

The type of paper as specified on the
printer does not match the type speci-
fied in the printer driver.

Change the type of paper in the printer driver and try printing again.

The paper is wrinkled or warped.

Straighten out the wrinkles or curls and reload the paper. Do not use paper that has been
printed on previously.
 (See "Loading Rolls in the Printer.")

A cut line is printed because CutDus-
tReduct. is On in the Control Panel
menu to reduce cutting dust.

If this function is not needed, set CutDustReduct. to Off in the Control Panel menu.
 (See "Menu Settings.")

The Printhead is set too low in the
Control Panel menu.

In the Control Panel menu, set Head Height to Automatic.
 (See "Troubleshooting Paper Abrasion and Blurry Images.")

You are printing on heavyweight paper
or paper that curls or wrinkles easily af-
ter absorbing ink.

For paper-based media such as Heavyweight Coated Paper, set the VacuumStrngth to
Strong or Strongest in the Control Panel menu. If the paper still rubs against the print-
head, set the Head Height in the Control Panel menu to a higher value than the current
setting.
 (See "Adjusting the Vacuum Strength.")

For film-based media such as Tracing Paper, set the VacuumStrngth to Standard,
Strong or Strongest in the Control Panel menu. If the paper still rubs against the print-
head, set the Head Height in the Control Panel menu to a higher value than the current
setting.
 (See "Adjusting the Vacuum Strength.")

The Ejection Guide is soiled.

Clean the Ejection Guide.
 (See "Cleaning the Printer Exterior.")

Cause

Corrective Action

The Paper Retainer is soiled.

Clean the Paper Retainer.
 (See "Cleaning Inside the Top Cover.")

You are using a paper that
does not dry easily.

In the Control Panel menu, set Roll DryingTime to at least 1 min.
 (See "Menu Settings.")

When paper that does not dry easily is used for printing, it may curl during printing and touch the
Output Tray.
In this case, in the Control Panel menu, complete the settings for Dry time and Area in Scan
Wait Time.
However, note that printing will now take longer.
 (See "Menu Settings.")

Cause

Corrective Action

The Platen has become dirty after borderless
printing or printing on small paper.

Open the Top Cover and clean the Platen.
 (See "Cleaning Inside the Top Cover.")

In the Control Panel menu, set CarriageScanWdth to Fixed.
 (See "Menu Settings.")

The Platen has become soiled because you have
set Width Detection to Off in the Control Panel
menu.

Set Width Detection to On in the Control Panel menu, and then open the Top
Cover and clean the Platen.
 (See "Cleaning Inside the Top Cover.")

Open the Top Cover and clean the Platen. After this, manually advance the roll
onto the Platen before printing.
 (See "Cleaning Inside the Top Cover.")

The Platen suction is too strong.

In the Control Panel menu, reduce the level of VacuumStrngth.
 (See "Adjusting the Vacuum Strength.")

iPF8400SE

                                                                                                                                                                 

The surface of the paper is dirty

                                                                                                                                                                                                                     

Troubleshooting

Problems with the printing quality

593