Справочник Пользователя для Citizen Systems PMU2XXX

 

- 102 - 

GS V m  ・・・ (1) 
GS V m n  ・・・ (2) 

 

 

Cutting the paper

 

 

 (1)<1D>H<56>H<m>   

(2)<1D>H<56>H<m><n> 

 

 (1)0≦m≦1、48≦m≦49 

(2)m=65、66 

0≦n≦255 

 

[Outline] 

 

Performs the specified paper cutting.

 

 

0,48 Full 

cut 

1,49 

Partial cut (Leaving a bridge area uncut) 
Paper feed by “cut position + {n×basic calculation pitch}” and full cut 

65 

Paper feed by “cut position + {n×basic calculation pitch}” and partial cut 

66 

 

 

   

• In STANDARD MODE, this command only works when it is entered at the beginning of a line. 
• Control to make the length of cut paper less than 10 mm is not executed.

   

 

For (1): 

• Executes cutting of paper. 

 

For (2):

 

• If n = 0, the paper is fed to the cut position, and then cut. If n ≠0, the paper is fed by “n x 

basic calculation pitch” inches past the cut position, and then cut. 

• The basic calculation pitch is set by GS P. The paper feed amount is calculated with the vertical 

basic calculation pitch (y). A fraction resulting from the calculation is corrected with the 
minimum pitch of the mechanism, and the remainder is omitted. 

 

 

/

/

/

/

• With label- or BM-supported model, this command does not function at the setting of BM 

paper/label paper setting.