Справочник Пользователя для FARGO electronic DTC300M

RESTRICTED USE ONLY 

 

Fargo Electronics, Inc. 

DTC400/DTC300/DTC300M Firmware Upgrade Document (Rev. 1.3) 

4

 

Information that raises potential safety issues is indicated by a warning 
symbol (as shown to the below). 
•  To prevent personal injury, refer to the following safety messages 

before performing an operation preceded by this symbol.  

•  To prevent personal injury, always remove the power cord prior to 

performing repair procedures, unless otherwise specified.  

•  To prevent personal injury, make sure only qualified personnel 

perform these procedures. 

 

This device is electrostatically sensitive. It may be damaged if 
exposed to static electricity discharges.  

Information that raises potential electrostatic safety issues is indicated by 
a warning symbol (as shown to the below). 
•  To prevent equipment or media damage, refer to the following 

safety messages before performing an operation preceded by this 
symbol. 

•  To prevent equipment or media damage, observe all established 

Electrostatic Discharge (ESD) procedures while handling cables in or 
near the Circuit Board and Printhead Assemblies.  

•  To prevent equipment or media damage, always wear an 

appropriate personal grounding device (e.g., a high quality wrist strap 
grounded to avoid potential damage). 

•  To prevent equipment or media damage, always remove the 

Ribbon and Cards from the Printer before making any repairs, unless 
otherwise specified.  

•  To prevent equipment or media damage, take jewelry off of fingers 

and hands, as well as thoroughly clean hands to remove oil and 
debris before working on the Printer.