Справочник Пользователя для FARGO electronic C16

RESTRICTED USE ONLY

Fargo Electronics, Inc.

Persona C16 Card Printer Service Manual (Rev. 5.0)

196

Removing and replacing the Idler Springs on the C11 Card Printers without the
Magnetic Encoder and for all C16 Card Printers (continued)

Step Procedure

Follow these steps to install the new parts:
a. Install two (2) spacers (D810050). (Note: Install one (1) spacer on each

set of posts.)

b. Install one (1) roller.

Caution: If there was a black Roller, ensure that the black Roller

was installed to the location closest to the input of the Printer.

c. Install one (1) Idler Spring (D830068) on top of each Roller (with the tabs

down).

Caution: When installing the springs, ensure that the Spring is

centered about the centerplate tabs. This ensures that the tabs do not
interfere with the spring.

d. Fasten four (4) screws (F000170) with four (4) washers (140040) into each

Post.

Caution: Do not over-tighten the screws.

Replace the bottom access cover and fasten the two (2) screws.

Turn the Printer upright.