Справочник Пользователя для Epson TM-P60
Rev. D
FAQ E-1
TM-P60 Technical Reference Guide
Appendix E
FAQ
Q 1. Can I use the TM-P60 in the Ad-Hoc mode?
A 1.1 The TM-P60 supports the Ad-Hoc mode for the first setup only.
The TM-P60 changesthe network mode to “Infrastructure“ automaticaly when any wireless
LAN setting is changed (IP address, SSID, WEP key, etc...)
LAN setting is changed (IP address, SSID, WEP key, etc...)
When you are using the TM-P60 in Ad-Hoc mode, there are some products that can’t
communicate with the TM-P60. Therefore, please use the TM-P60 in the Infrastructure mode.
communicate with the TM-P60. Therefore, please use the TM-P60 in the Infrastructure mode.
Q 2. Buzzer sounds when the TM-P60 is turned on. What should I do?
A 2.1 Confirm whether the POWER LED is flashing slowly or not
When TM-P60 is turned on, it searches for an access point for wireless communication when
TM-P60 is in infrastructure mode. (In Ad-Hoc mode, TM-P60 serches for an host PC which is in
Ad-Hoc mode) If the TM-P60 is out of wireless communication range, the POWER LED flashes
slowly and the buzzer sounds. In this case, try following items.
TM-P60 is in infrastructure mode. (In Ad-Hoc mode, TM-P60 serches for an host PC which is in
Ad-Hoc mode) If the TM-P60 is out of wireless communication range, the POWER LED flashes
slowly and the buzzer sounds. In this case, try following items.
❏ Confirm the wireless LAN settings of the TM-P60 and the access point. (Ex. SSID, IP
address, submet mask, WEP key etc..) The TM-P60’s self test shows you the current settings
except WEP key. See “Self test mode” (page 3-3) for procedure of self test.
except WEP key. See “Self test mode” (page 3-3) for procedure of self test.
❏ There is no access point or PC in the range where the communication is possible. When there
are obstructions between the AP or PC and the TM-P60, move the TM-P60 and confirm that
the LED does not flash.
the LED does not flash.
A 2.2 Confirm whether the ERROR LED lights or flashes
The TM-P60 beeps when error occurs depending on the memory switch setting. Confirm the
error cause, and see “Beeping Types” (page 3-2).
error cause, and see “Beeping Types” (page 3-2).
Q 3. How to set the buzzer not to sound.
A 3.1 Change Memory switch setting.
The buzzer does not sound if the Memory switch setting is changed. About memory switch, See
“Memory Switches” (page 2-11).
“Memory Switches” (page 2-11).
Q 4. BATT LED lights or flashes. What should I do?
A 4.1 There is no remaining battery charge.
You can confirm the remaining battery charge by the BATT LED condition. (See “About the
Battery Remaining Amount” (page 4-2))
Battery Remaining Amount” (page 4-2))
About procedure for battery charging, see “Charging the battery” (page 2-9).