Справочник Пользователя для Samsung JE68-00131B

 

10 

6. Setting The Dip Switches   

 

 

The Dip Switches are located on the bottom of the printer. The Dip Switches are used to 

set the Printer to perform various functions. Follow these steps when changing Dip 

Switches setting : 

1.  Turn the printer power switch off. 

2.  Remove the screw on the bottom of the printer and open the bracket. 

3.  Flip the Dip Switches using tweezers or another narrow-ended tool. Switches are 

off when up and on when down in the Figure below. 

4.  The new setting takes effect when you turn on the printer. 

 

 

 

Note : Always change Dip Switch settings only when the printer is turned off.   

 

 

 

 

6-2-1. Dip S/W 1                                                    6-2-2. Dip S/W 2 

2 

1 

Speed 

Off Off

2.5 

ips 

Off On

3.0 

ips 

On Off

4.0 

ips 

1,2 

Speed 

Selection 

On On

5.0 

ips 

4 

3 

Density 

Off Off

0(Low) 

Off On

7 

On Off

13 

3,4 

Density 

Selection 

On On

20(High) 

5,6,

7 

Developer 

Mode 

Default --- off 

Off  Move to Cutting Position 

8 

Position 

Selection 

On  Move to top of next page 

2

1 

Baud Rate 

Off

Off

9,600 bps 

Off

On

19,200 bps 

On

Off

57,600 bps 

1,2 

Baud 

Rate 

On

On

115,200 bps 

3 Reserved 
4 Reserved 

5~8 

Developer

Mode 

Default --- off 

 

 

11

7. The Self Test   

 

The self-test checks whether the printer has any problems. (You cannot perform this 

procedure if using the printer’s label peel-off option) If the printer does not function 

properly, contact your dealer. The self-test checks the following; 

 
1.  

Make sure that paper roll has been installed properly. 

2.  

Turn on the power while holding(2sec) down the FEED button. The self-test begins.

 

3.  

The self-test prints the current printer status, which provides the control ROM version 

and the DIP switch setting. 
 

             

 

 

※

Paper dust on the heating elements may lower the printer quality. In this case, clean the 

print head as follows : 

 

Cautions 

 

1. Turn Off the printer power before cleaning. 

                    2.  Note  that  the  thermal  head  becomes  very  hot  during  normal  operation, 

                        creating  the  danger  of  burn  injury.  Be  sure  to  wait  for  about  10  minutes 

                        after turning printer power off before beginning the cleaning.   

             

        1. Open the printer cover. 

        2. Clean the thermal element (the area which is marked a thin black line) of the 

      thermal head with a cotton swab moistened with a alcohol solvent (ethanol, 

            methanol, or IPA). 

        3. After confirming that the alcohol solvent has been dried up completely, 

            close the cover-open.