Справочник Пользователя для Samsung SRP-500
63
①
GS V m
②
GS V m n
[Name]
Feeds paper for cutting position.
[Format]
①
1 ASCll GS V
m
Hex
1D
56 m
Decimal 29
86 m
②
ASCll
GS V
m
n
Hex
1D
56 m
n
Decimal 29
86 m
n
[Range]
①
m = 1, 49
②
m = 66, 0 ≤ n ≤ 255
[Description]
Feeds paper for cutting position as follows;
Bit
Print mode
1, 49
Partial cut (one portion left uncut)
66
Feeds paper for ( cutting position + [n x 0.122 mm {1/192 inches}]), and partial cut.
[Notes]
• This command is effective only at the beginning of a line.
• When n = 0, the printer feeds the paper to the cutting position.
• When n , 0,the printer feeds the paper to (cutting position +[ n x 0.122 mm
{1/192 inches}]).
GS a n
[Name]
Enable/Disable Automatic Status Back
[Format]
ASCII
GS
a
n
Hex
1D
61
n
Decimal 29
97
n
[Range]
0 ≤ n ≤ 255
[Description]
Enables or disables ASB and specifies the status items to
include, using n as follows:
include, using n as follows:
64
Bit
Off/On
Hex
Decimal
Status for ASB
Off
00
0
Drawer kick-out connector pin 3 status disabled.
0
On
01
1
Drawer kick-out connector pin 3 status enabled.
Off 00 0 On-line/off-line
disabled.
1
On 02 2 On-line/off-line
enabled
Off 00 0 Error
status
disabled.
2
On 04 4 Error
status
enabled.
Off
00
0
Paper roll sensor status disabled.
3
On
08
8
Paper roll sensor status enabled.
4 - - - Undefined.
5 - - - Undefined.
6 - - - Undefined.
7 - - - Undefined.
5 - - - Undefined.
6 - - - Undefined.
7 - - - Undefined.
[Notes]
• Even if only one of the statuses is enabled, the status is sent when this
command is executed. Subsequently, whenever the state of a valid status
changes, that status is sent. In this case, because the current state is
shown for each status, there is a possibility of a state change for a status
for which ASB is not enabled.
changes, that status is sent. In this case, because the current state is
shown for each status, there is a possibility of a state change for a status
for which ASB is not enabled.
• If all statuses are disabled, the Automatic Status Back (ASB) function is
disabled.
• When transmitting a status, the printer transmits only four bytes.
• Four bytes of status data must be consecutive, except for XOFF code.
• This command is executed when the data in the receive buffer is
• Four bytes of status data must be consecutive, except for XOFF code.
• This command is executed when the data in the receive buffer is
developed. Therefore, there may be a time lag between receiving this
command and transmitting the status, depending on the receive buffer
status.
command and transmitting the status, depending on the receive buffer
status.
• When the printer is disabled by ESC = (Select peripheral device), this
command is disabled but ASB is not disabled.
• The status to be transmitted are as follows: