Справочник Пользователя для Samsung 1865

Getting started_ 22

2.

getting started

This chapter gives you step-by-step instructions for setting up the USB connected machine and software.

•

•

•

•

•

•

  

This section shows the steps to set up the hardware, as is explained in the 

Quick Install Guide. Make sure you read the Quick Install Guide first and 

follow the steps below:

Select a stable location.
Select a level, stable place with adequate space for air circulation. Allow 

extra space for opening cover(s) and tray(s). 
The area should be well ventilated and away from direct sunlight or 

sources of heat, cold, and humidity. Do not set the machine close to the 

edge of your desk or table.

Printing is suitable for altitudes under 1,000 m (3,281 ft). 
Place the machine on a flat, stable surface so that there is no incline 

greater than 2 mm (0.08 inch). Otherwise, printing quality may be 

affected.

Unpack the machine and check all the enclosed items.

Remove tape holding the machine securely.

Install the toner cartridge.

Load paper. (See "Loading paper in the tray" on page 29.)

Make sure that all cables are connected to the machine. 

Turn the machine on. (See "Turning on the machine" on page 21.)

This machine will not operate when the power main fails.

Print a configuration page to make sure that the machine is operating 

properly.
To print a configuration page:

In the ready mode, press and hold 

 for about 10 seconds until the green 

LED blinks slowly, and release. 

•

Use this driver to take full advantage of 

your machine’s features.

•

This program combines device 

settings as well as printing environments, settings/actions 

and launching. All of these features provide a gateway to 

conveniently use your Samsung machine.

•

This program monitors and informs you 

of the machine status.

•

Use this driver to take full advantage of 

your machine’s features.

•

This program allows you to monitor the 

machine’s status.

•

Use this driver to take full 

advantage of your machine’s features.

•

This program allows you to monitor the 

machine’s status and alerts you when an error occurs 

during printing.