Справочник Пользователя для Samsung 1865

Media and tray_ 29

Open front cover and pinch the paper length guide and pull it out to 

extend the tray.

Because the machine is very light, it can move when you open and 

close the tray or install and remove the toner cartridge. Be careful 

not to move the machine when performing these tasks.

Flex or fan the edge of the paper stack to separate the pages before 

loading the paper. Insert the paper into the tray.

Load paper with the print side facing up. Make sure that all four corners 

are flat in the tray.

Do not overload the tray with paper. Otherwise, it may cause paper 

jams.

Pinch the paper length guide to adjust the guide so that it is flush up 

against the rear edge of the paper; then pinch the paper width guides so 

they are flush against the sides of the paper.

•

Do not push the paper width guide too far causing the media to 

warp. 

•

Do not use a paper with more than 6 mm (0.24 inch.) curl. 

•

If you do not adjust the paper width guide, it may cause paper 

jams.

Open the front cover, pinch the paper length guide and pull it out to 

extend the tray. Then, adjust the tray size to the media size you are 

loading. (See "Changing the tray size" on page 28.)

Flex or fan the edge of the paper stack to separate the pages before 

loading papers.

Place the paper with the side you want to print facing up.

When you print a document, set the paper type and size for the tray.
For information about setting the paper type and size on the control 

panel (See "Setting the default tray and paper" on page 27).

•

If you experience problems with paper feeding, check whether 

the paper meets the media specifications. Then, try placing 

one sheet at a time in tray (See "Print media specifications" on 

page 62, "Printing on special media" on page 30).

•

The settings made from the machine driver override the 

settings on the control panel.

The tray can hold special sizes and types of print material, such as 

postcards, note cards, and envelopes. It is useful for single page printing on 

letterhead or colored paper.

•

If you select Paper > Source > Manual Feeder from your printer 
driver, you need to press 

 each time you print a page.

Load only one type, size and weight of print media at a time in the 

tray.

•

To prevent paper jams, do not add media while printing. 

•

Print media should be loaded face up with the top edge going into 

the tray first and be placed in the center of the tray.