Справочник Пользователя для Ricoh SP 4510DN

Problem

Cause

Solution

Printing does not start when
using the extended wireless
LAN in Ad-hoc Mode.

The correct Communication
Mode is not set.

• Turn the main power switch

off and then back on
again. For details about
how to turn on/off the
main power switch, see
page 26 "Turning On/Off
the Power".

• Change [Communication

Mode] in [System Settings]
to [802.11 Ad-hoc
Mode], and then select
[Off] for [Security
Method]. For details about
Communication Mode,
see:

• "Host Interface",

Operating Instructions
(for SP 4510DN)

• "Interface Settings",

Operating Instructions
(for SP 4520DN)

If printing does not start, contact your service representative.

When the Data In Indicator Does Not Light Up or Flash

When the Data In indicator does not light up or flash after a print job starts, data is not being sent to the
printer.
When the printer is connected to the computer using the interface cable

Check that the print port setting is correct. When connecting the printer to the computer using a
parallel interface, connect using LPT1 or LPT2.

1.

Open the printer properties dialog box, and then click the [Ports] tab.

For details about displaying the printer properties dialog box, see "Displaying the Printer
Driver Properties with Windows", Operating Instructions.

2.

In the [Print to the following port(s)] list, check that the correct port is selected.

Network connection

For details about the network connection, contact your administrator.

When You Cannot Print

101