Справочник Пользователя для M-S Cash Drawer 7193

Скачать
Страница из 118
7193 Owner’s Guide
Setting Up the Printer
May 1996
Mounting the Power Supply on a Wall
The power supply comes with a wall-mount kit to mount the power supply on
the wall or under a table. See “Ordering Paper and Supplies” in the chapter,
“About the 7193 Printer,” for information on ordering the power supply and
wall-mount kit.
The kit contains a holder and screws with plastic anchors. Be sure there are no
hidden wires or other obstructions in the wall where you mount the power
supply.
You will need a 1/4 inch drill bit and either a Phillips or standard screwdriver
(screws are combination Phillips and pan-slotted).
1.  Using the bracket as a template, mark and drill a hole for each plastic anchor
1.25 inches deep.
2.  Insert the anchors into the holes so they are flush with the wall surface and
screw the holder against the wall, tightening the screws so that the plastic
anchors expand and hold firmly in the wall.
Do not overtighten the screws.
Note:
  You must unplug the power cord in order to place the power supply in the
holder. First, take the printer off-line by pressing the On Line button on the
operator panel (the On Line light goes off indicating the printer is off-line),
unplug the power cord from the outlet, then unplug the power cord from the
power supply.
3.  Place the power supply in the holder.
4.  Plug the power cord into the power supply.
5.  Plug the power cord into an outlet.
Note:
  You can use the tie-wrap to wrap the power supply cable to keep it out of
the way.