Справочник Пользователя для LevelOne EPS-3001TU
Level One Printer Servers
• If the printouts are the same, then the problem is NOT the
LevelOne Printer Server. The problem might be that an
incorrect printer driver was chosen or the timeout setting in
the CAPTURE command is too short.
incorrect printer driver was chosen or the timeout setting in
the CAPTURE command is too short.
• If the printouts are NOT the same, there may be a problem
with the LevelOne Printer Server. Call your dealer.
7. Re-enable queue service.
• Disconnect the printer attached to LPT1 of your PC and
connect it to your LevelOne Printer Server.
• For NetWare 2.x or 3.x, run PCONSOLE and Select Print
Queue Information. Then select the LevelOne Printer
Server's print queue and select Current Queue Status. Set
Servers can service entries in queue to YES
Server's print queue and select Current Queue Status. Set
Servers can service entries in queue to YES
• For NetWare 4.x bindery and NDS modes, run PCONSOLE
and select Print Queues.
Then select the print queue and select Status.
Set Allow service by current print servers to YES.
Then select the print queue and select Status.
Set Allow service by current print servers to YES.
Problem No. 2
My LevelOne Printer Server does not appear in the Active
Device List of the PSConfig program.
Device List of the PSConfig program.
Solution No. 2
• Ensure that the LevelOne Printer Server is on the same network
segment as your PC.
• Load the NetBEUI protocol on your PC, so that PSConfig can
try connecting using NetBEUI. Once connected, check the
following:
following:
• The NetWare protocol is enabled.
• The Ethernet frame type of your PC may be different than the
• The Ethernet frame type of your PC may be different than the
one with your LevelOne Printer Server. Enable all Ethernet
frame types.
frame types.
Problem No. 3
My LevelOne Printer Server is configured as a Novell Print
Server, and cannot log in to a file server.
Server, and cannot log in to a file server.
Solution No. 3
The following steps may solve this problem:
1. Get the LevelOne Printer Server information using PSConfig. If
the device is configured as a Novell Print Server, the information
will look like the following:
will look like the following:
Server Name: PS110049
NetWare Information:
Master File Server: ICE
Print Server Mode Status:
Your_File_Server: Current Status
Remote Printer Mode Status: N/A
NetWare Information:
Master File Server: ICE
Print Server Mode Status:
Your_File_Server: Current Status
Remote Printer Mode Status: N/A
2. Make sure the master file server name is assigned correctly.
3. Check the Current Status of Your_File_Server:
• Connected: No action required
• No file server: Assign a master file server using PSConfig
• Connecting to Server: Wait and check if the file server
• No file server: Assign a master file server using PSConfig
• Connecting to Server: Wait and check if the file server
exists
- 82 -