Справочник Пользователя для KYOCERA 2020D

7-56

Using the Operation Panel

Use this procedure to set the amount of memory used for the RAM disk.

1

Press 

Z while >RAM Disk Mode On > is displayed.

2

Press 

[OK]. The message display shows a blinking cursor (_). Press 

U or V to display the desired size. Definable RAM disk size is 001

 

to 

512

.

 Use 

Y and Z to move the cursor right and left.

This range varies depending on the total memory size of the printer. 
The setting exceeding this range is automatically adjusted to the 
maximum RAM disk size.

3

When the desired RAM disk size is displayed, press 

[OK].

4

Press 

[MENU]. The display returns to Ready. Turn the printer off 

and then on again. The selected RAM disk size is activated after the 
printer is restarted.

Installing the optional hard disk into the printer allows you to perform the 
following operations on the hard disk.

Format (Formatting hard disk)

When an optional hard disk is inserted into the printer for the first time, it 
must be formatted before use.

This menu is displayed only when the optional hard disk is installed on 
the printer.

1

Press 

Z while Device Common > is displayed.

2

Press 

U or V repeatedly until >Hard Disk > appears.

The RAM Disk Size menu option only appears when 

RAM Disk Mode

 is set to 

On

.

>>RAM Disk Size
        119MByte

Note If the optional hard disk is installed in the printer, the 

Job Box will be available.

>Hard Disk     >