Справочник Пользователя для KYOCERA 2020D

6-10

Troubleshooting

01

Hard disk format error. If this error recurs even if the power has been turned 
off and then on, reformat the hard disk.

02

The disk system is not installed. Recheck the requirements for using the 
system and the devices.

04

There is no available hard disk space. Delete unnecessary files, etc., in 
order to free up space.

05

The specified file does not exist in the hard disk.

06

There is no memory available to the hard disk system. Increase the 
available memory.

10

Formatting is not possible because host data is being spooled on the hard 
disk. Wait until the hard disk is ready, and then format.

97

The number of permanent code jobs that can be stored reached the limit 
value, and no more can be saved. Either delete some unnecessary jobs, 
etc., or increase the limit.

98

An unreadable page was found in a job (The job is damaged.).

99

A print job for the specified ID does not exist in the hard disk.

01

The printer does not support the CF card inserted, or the CF card is broken. 
Insert the correct CF card.
For more information, refer to Memory Card (Using the memory card) section 
in the Advanced Operation Guide.

02

The CF card is not installed. Recheck the requirements for using the system 
and the CF card.

03

The CF card is write protected. Check the CF card's status.

04

There is not enough space in the CF card. Delete unnecessary files or use a 
new CF card.

05

The specified file is not on the CF card or the USB flash memory.

06

There is not enough printer memory to support the CF card system. Increase 
printer memory.

50

The USB flash memory is write protected, or invalid. Check the USB flash 
memory’s status.