Справочник Пользователя для Seiko FB 390

 

6

3  Pull the Sub friction roller by gripping the center area of the unit by your 

forefingers. Then lift it up until it is positioned upwards towards the top of the 

printer as shown in Figure 2-5. 

4 

If necessary, move and centre the print head carefully by hand.   

5 

Hold the ribbon cartridge with the knob facing upwards and turn the ribbon knob 

in the direction shown by the arrow to take up any slack in the ribbon. 

6 

To install the ribbon cartridge, hold it with both hands, with the ribbon facing 

down as shown if Figure 2-6.   

 

 

 

 

 

 

 

 

 

 

               

  Figure 2-6 Installing the ribbon cassette 

 

 

 

When you look at the print head you will find a small piece of black plastic 

on the thin metal sheet of the ribbon guide. Make sure that the ribbon goes 

under the piece of plastic. 

 

Position the ribbon cartridge with the tabs on its case over the slots inside 

the printer case. 

 

With the ribbon cartridge and ribbon correctly positioned, gently push the 

cartridge towards the back of printer until it clicks into place. 

 

7 

Move the print head from side a few times to make sure the ribbon slides into 

the ribbon guides. 

8 

Having installed the ribbon, lower the sub friction roller and gently push it shut 

until you hear a click. Then close the window cover. 

Connect the parallel or USB interface cable as shown in figure 2-7 on the next page: 

 

Make sure that the power switches of both printer and host computer are turned OFF before you 

connect the parallel interface cable.