Справочник Пользователя для Savin C4535

Transmission Features

8

When sending a fax message using
the Document Feeder (ADF), the ma-
chine can stamp a circle mark at the
top of the original. When sending a
double sided document, they are
marked at top left of the front page
and top right of the rear page. This
stamp indicates that the original has
been successfully stored in memory
for Memory Transmission, or that it
has been successfully sent for Imme-
diate Transmission.

❒ Stamp only works when scanning

from the Document Feeder (AR-
DF).

❒ You cannot turn the Stamp feature

on or off while a document is being
scanned.

❒ Do not open the document feeder

(ARDF) while scanning the docu-
ment. Document jam could occur.

❒ When the Stamp Unit is installed,

{F5} key is automatically assigned
as the Stamp key.

❒ When the stamp starts getting

lighter, replace the cartridge. 

⇒

P.145  “Replacing the Stamp Car-
tridge”

❒ If a page was not stamped even

though the Stamp feature is turned
on, you need to re-send that page.

❒ By default, Stamp is turned off. If

you use this feature often, you can
adjust the User Parameters so that
the home setting is on. In this case,
Stamp can easily be turned off for
any single transmission by press-
ing the 

{F5} key. ⇒ P.130 “Chang-

ing the User Parameters”(Switch00,
Bit0)

A

{{{{F5}}}} key.

The Stamp indicator will light.
Pressing the 

{F5} key again will

turn it off.

This feature allows you to restrict
transmission of messages only to ma-
chines of the same make, and only to
those machines that have the same
Polling ID. The transmission options
let you switch ID transmission on and
off for each separate transmission.

❒ The default setting is off. Turn this

feature on with the User Parame-
ters. 

⇒ P.130 “Changing the User

Parameters”(Switch01, Bit1)

LCSTAP01GB.eps

TX File
Status

Immediate
Trans.

Memory
Trans.

Standard

Detail

Super Fine

Commu-
nicating

Receive
File

Confidential
File

Start
Manual RX

TEL
Mode

LTWO150E.eps