Справочник Пользователя для JVC CX-7000 Series
3
Align the orientation of the cards, and set them in the printer
m
Magnetic stripe cards
v
Set the card with the magnetic stripe facing upward and toward
the printer, or facing downward and toward you.
the printer, or facing downward and toward you.
.
m
ISO contact IC cards
v
Set the card with the Contact IC terminal facing upward and
toward the rear of the printer, or downward and toward the rear of
the printer.
toward the rear of the printer, or downward and toward the rear of
the printer.
v
For single-sided printers, set the cards with the IC terminal facing
down and toward the rear of the printer.
down and toward the rear of the printer.
.
4
Install the card hopper cover, and set the card hopper knob to
[LOCK]
[LOCK]
.
m
Adjusting card thickness
v
The thickness of a card that is adjustable is between 0.25 mm and
1.00 mm.
This is adjusted to a thickness of 0.76 mm by default.
A
1.00 mm.
This is adjusted to a thickness of 0.76 mm by default.
A
Set the card hopper knob to [LOCK]
.
B
Remove the card hopper
.
C
Insert a ballpoint pen into the card separator hole, and turn
slowly
v
Adjust according to the range of the card thickness used.
.
Memo:
v
If the card cannot be discharged during printing, adjust the card
thickness by turning the card separator in the clockwise
direction by one scale at a time.
thickness by turning the card separator in the clockwise
direction by one scale at a time.
v
If two cards are discharged at a time during printing, adjust the
card thickness by turning the card separator in the anti-
clockwise direction by one scale at a time.
card thickness by turning the card separator in the anti-
clockwise direction by one scale at a time.
D
Install the card hopper
.
Setup
63