Справочник Пользователя для IBM RS/6000 44P
Before you load the cleaning cartridge, make sure the power to the tape drive is on.
1
Window side of tape cartridge
2
8 mm cleaning cartridge
3
Write-protect tab
To clean the tape path:
1. Grasp the edges of the 8 mm cleaning cartridge with the window side of the
cartridge facing up. Slide the cartridge into the opening on the front of the 8mm
Tape Drive until the loading mechanism pulls it into the drive.
Tape Drive until the loading mechanism pulls it into the drive.
2. After you fully insert the 8 mm cleaning cartridge into the 8mm Tape Drive, the
following cleaning operations are automatically performed:
v
The cleaning tape loads into the tape path. The message
CLEANING...
displays.
The cleaning cycles take approximately two minutes.
v
The tape unloads and the cleaning cartridge ejects from the tape drive upon
completion of the cleaning operation.
completion of the cleaning operation.
v
The amber disturbance status light goes off if the cleaning operation was
successful.
successful.
3. Record the use of the cleaning cartridge on the cartridge.
28
44P Series Model 170 User’s Guide