Справочник Пользователя для HP (Hewlett-Packard) 076064 REV C

◆

Reset Reg Data - resets all registration data to their factory 
default values.

This menu consists of two submenus: Settings and Modes.

◆

Takeup Direction - (available if takeup motor is installed) 
allows you to wind the printed output onto the takeup spool 
Image Inside or Image Outside.

◆

Space Between Prints - allows you to set the amount of 
blank space between prints.

◆

Top Gutters - allows you to enable or disable the top gutter 
pattern, which displays technical details about the print, out-
side the top edge of the print.

◆

Side Gutters - allows you to enable or disable the side gut-
ter pattern, which fires all jets in a narrow, medium, or wide 
pattern at the right and left edges of the print, for trouble-
shooting purposes.

◆

Service Station - allows you to specify the print head ser-
vice station spit-and-wipe cycle: 30 seconds, 90 seconds 
(default), or 30 seconds with spit only (no wipe).

◆

Humidity Sensor - allows you to use the printer’s prepro-
grammed algorithm for slowing the print speed when the 
ambient relative humidity is excessive, or allows you to spec-
ify a custom print speed. Slower print speeds allow ade-
quate drying under higher ambient relative humidity.

◆

Vacuum Fan Speed - allows you to control the speed (and 
therefore suction power) of the vacuum fans. Maximum 
speed is recommended for most media, but lighter or polyes-
ter film media may require a slower speed for best results.

◆

AutoSet Summary - allows you to enable or disable the 
printed summary of an AutoSet calibration.

◆

Units - allows you to display values in U.S. or metric units of 
measure.

◆

Dryer Fan - allows you to disable the dryer fan (if installed)  
to avoid streaking output on films such as ViewThrough 
Backlit.

◆

3x Mode - specifies the mode to use when the printer 
detects that three four-color ink sets are loaded (if 
upgraded).