Справочник Пользователя для IBM 1585 (MT 4539)
Adjusting Power Saver
106
Administrative support
Adjusting Power Saver
To adjust the
Power Saver
setting:
1
Make sure the printer is on and
Ready
appears on the display.
2
Press
on the operator panel.
3
Press
until
Settings
appears, and then press
.
4
Press
until
Setup Menu
appears, and then press
.
5
Press
until
Power Saver
appears, and then press
.
6
Using the numeric pad or the right and left arrows on the operator panel, enter the number of minutes for the
printer to wait before entering Power Saver.
printer to wait before entering Power Saver.
The settings available range from 2–240 minutes. If you want to turn Power Saver off, see Disabling Power Saver
on page 106.
on page 106.
7
Press .
Submitting Selection
appears.
Note: You can also adjust the Power Saver setting by issuing a Printer Job Language (PJL) command.
Disabling Power Saver
Disabling Power Saver is a two step process. First, you must turn the variable on, and then select the variable. To disable
Power Saver:
Power Saver:
1
Turn the printer off.
2
Press and hold
and
while turning the printer on.
3
Release both buttons when
Performing Self Test
appears on the display.
The printer performs its power-on sequence, and then
Config Menu
appears on the first line of the display.
4
Press
until
Energy Conserve
appears, and then press
.
5
Press
until
Off
appears, and then press
.
Submitting Selection
appears.
The operator panel returns to
Energy Conserve
.
6
Press
until
Exit Config Menus
appears, and then press
.
Resetting the Printer
appears briefly followed by a clock. The operator panel then returns to
Ready
.
7
Make sure
Ready
appears.
8
Press
on the operator panel.
9
Press
until
Settings
appears, and then press
.
10
Press
until
Setup Menu
appears, and then press
.
11
Press
until
Power Saver
appears, and then press
.
12
Use either the numeric keypad or the right and left arrows to enter 0 (zero).
Disabled
appears, and then press
.
Submitting Selection
appears. Power Saver is now disabled.