Справочник Пользователя для IBM 6500
TCP/IP Access Problem
239
6.
From a workstation attached to this network segment, create
an ARP entry. The Ethernet Interface IP address and hardware
or MAC address are needed. At the workstation, enter:
an ARP entry. The Ethernet Interface IP address and hardware
or MAC address are needed. At the workstation, enter:
arp -s <ipaddress> <MACaddress>
ping <ipaddress>
7.
Try to ping this IP address to see if the Ethernet Interface can
be seen on your network. If the interface does not respond,
verify you are on the same network segment as the printer and
that the ARP entry was created.
be seen on your network. If the interface does not respond,
verify you are on the same network segment as the printer and
that the ARP entry was created.
8.
Telnet
into the Ethernet Interface using the same IP address
as above. Log in as root with no password.
9.
At system prompt, enter:
store tcpip from default
config http on
reset
NOTE: This will reset all TCP/IP settings to factory default and
reset the Ethernet Interface.
10. Wait five minutes for the Ethernet Interface to reset.
11. Power the printer off and then back on.
12. Wait for the “ETHERNET IS READY” message to display.
13. Set the IP address, subnet mask, and default gateway
parameters to the desired values. (See “Configuration Tools”
on page 52.)
on page 52.)