Справочник Пользователя для Zebra Technologies P640i
Media Handling
Laminating Station
980541-001 Rev. A
P640i Card Printer User Guide
19
Clearing the Laminate Channels
If your scissor cuts were neat enough to pass for machine-made cuts, continue printing cards in
the usual way. If not, don’t waste a print cycle. Instead, remove the hand-cut patch(es) from
the transfer roller(s) as follows.
the usual way. If not, don’t waste a print cycle. Instead, remove the hand-cut patch(es) from
the transfer roller(s) as follows.
Removal of the Transfer Guide gives access
to the transfer roller.
to the transfer roller.
1.
Pull back the retaining spring, at the
same time pulling the Transfer Guide
straight out toward you.
same time pulling the Transfer Guide
straight out toward you.
2.
Remove and discard the laminate patch
on the transfer roller. Never re-use!
on the transfer roller. Never re-use!
3.
Re-install the Transfer Guide with its top
edge above the laminate cutter guide.
It’s easier if you pull back the retaining
spring while re-inserting the guide, then
release the spring as you push the guide
into position (it will click into place, with
its far leg against the back plate of the
laminator). Press the LAMINATE button
to load the transfer roller(s).
edge above the laminate cutter guide.
It’s easier if you pull back the retaining
spring while re-inserting the guide, then
release the spring as you push the guide
into position (it will click into place, with
its far leg against the back plate of the
laminator). Press the LAMINATE button
to load the transfer roller(s).
Important •
Clearing procedures for the
upper and lower channels are similar. The
upper channel is shown here.
upper channel is shown here.
Laminate cutter guide