Справочник Пользователя для Zebra Technologies S4M
Configuration
Password Protection of Parameters
Password Protection of Parameters
54
13290L-001 Rev. A
S4M User Guide
10/21/05
Password Protection of Parameters
The printer has four levels of passwords. When you enter Setup mode on the control panel,
only those parameters that are not password-protected are displayed. To see more parameters,
you must enter an appropriate password at the
only those parameters that are not password-protected are displayed. To see more parameters,
you must enter an appropriate password at the
ADVANCED SETUP
prompt. After you enter a
password correctly, you do not have to enter it again until you leave and reenter Setup mode.
When you are prompted for a password, enter the password for the level displayed or for a
higher level. Entering a higher level password will unprotect the parameters for that level and
for all levels below it (for example, unprotecting level 4 parameters also unprotects levels 1, 2,
and 3).
higher level. Entering a higher level password will unprotect the parameters for that level and
for all levels below it (for example, unprotecting level 4 parameters also unprotects levels 1, 2,
and 3).
The password levels and default passwords are shown in
. To change the password for
any level, use the
^KP
ZPL II command. For more information, see
To enter a password when prompted, complete these steps:
1.
When the printer displays
ADVANCED SETUP X
, press ENTER.
The printer displays
PASSWORD
and the number
0000
.
2.
Enter the four-digit password for the password level displayed or for a higher level.
•
The left and right arrows change the selected digit position.
•
The up and down arrows change the value of the selected digit.
3.
After entering the password, press ENTER.
If you entered a valid password, additional parameters are displayed.
If you entered a valid password, additional parameters are displayed.
Table 7 • Password Levels and Defaults
Password
Level
Features Controlled
Default Password
4
All features, including sensor adjustments
and other sensitive parameters
and other sensitive parameters
For advanced use only. See the
Maintenance Manual or contact
technical support.
Maintenance Manual or contact
technical support.
3
Installation and reconfiguration. The printer
web-page interface also uses this password.
web-page interface also uses this password.
1234
2
Label configuration operations (media type,
label removal method, label length)
label removal method, label length)
0000
(unprotected)
1
Darkness, Tear-Off position, label top
0000
(unprotected)