Справочник Пользователя для Zebra Technologies S4M

Routine Maintenance
Lubrication

13290L-001 Rev. A

S4M User Guide

10/21/05

No lubrication is needed for this printer.

Specific cleaning procedures are provided on the following pages. 

 shows the 

recommended cleaning schedule.

. 

You may clean the exterior surfaces of the printer with a lint-free cloth and a small amount of a 
mild detergent, if necessary. Do not use harsh or abrasive cleaning agents or solvents.

Some commercially available lubricants will damage the finish and the 

mechanical parts if used on this printer.

Zebra is not responsible for damage caused by the use of cleaning fluids on this 

printer.

Printhead

Solvent*

Direct Thermal Mode: After every roll of 
media (or 500 feet of fanfold media).
Thermal Transfer Mode: After every roll of 
ribbon or three rolls of media.
These intervals are intended as guidelines only. 
You may have to clean more often, depending 
upon your application and media.

Platen roller

Solvent*

Media sensors

Air blow

Ribbon sensor

Air blow

Media path

Solvent*

Ribbon path

Solvent*

Pinch roller. (part of Peel-Off option)

Solvent*

Tear-off/peel-off bar

Solvent*

Once a month.

Take label sensor

Air blow

Once every six months.

* Zebra recommends using Preventive Maintenance Kit (part number 47362) or a solution of 90% Isopropyl and 

10% deionized water)