Справочник Пользователя для Toshiba A1

The following describes the procedure for installing the keyboard (See Figure 4-19 to 4-21). 

1.  Turn the keyboard upside down and place it on the palm rest as its face is down. Turn 

up the insulator and connect the keyboard flexible cable to PJ3200 on the system 
board. 

2.  Install the keyboard support plate on the insulator covering the keyboard flexible 

cable and secure it with the following screw. 

•  M2.5x8  THIN BIND screw 

x1 

3.  Turn the keyboard face up and put it on the computer. Make sure that there is no gap 

between the keyboard and the computer. 

4.  Insert the left side of the keyboard hold plate into the slot of the chassis. Set the plate 

with its hole attached to the guide pin on the chassis. Secure the keyboard hold plate 
with the following screw. When installing, make sure the “UP” mark on the keyboard 
hold plate is on the upper side and the plate holds the center tab on the keyboard. 

•  M2.5x2.8  THIN BIND screw 

x1 

5.  Secure the keyboard with the following screws. 

•  M2.5x2.8  THIN BIND screw 

x2 

6.  Install the keyboard holder by pressing it from the top side.