Справочник Пользователя для Toshiba 960-498

The following describes the procedure for installing the system board (See Figure 4-23 and 
4-24). 

1.  Connect the DC-IN jack, SD board flat cable and SVP harness to the system board. 

2.  Install the BATT CONN cover with fitting to the slot of the base assembly. 

3.  Install the DC-IN jack to the base assembly. 

4.  Install the system board. When installing, insert the battery connector under the 

BATT CON cover and the set the opposite side of the system board. When setting the 
board, be careful not to break the I/O connectors on the system board. Then secure 
the system board with the following screws. 

•  M2.5×4B   

FLAT BIND screw   

x4 

5.  Pass the USB cable along to the guide on the base assembly and secure the USB 

cable with the insulator. 

6.  Connect the VGA fan cable to the connector CN8780 on the system board from the 

bottom side.