Справочник Пользователя для IBM 150

RS/6000 43P 7043 Models 150 and 260 Handbook

STANDBY mode reflects the configuration during the last boot. To view the 
current configuration, access the SP menu after the system boots up. When 
you select a memory DIMM, its state will toggle between configured and 
deconfigured. Memory DIMMs that are not present are not listed. A memory 
DIMM can be in any of the following four states:

The memory DIMM is present, and has not 
exceeded the number of failures threshold. It is 
configured by the system and is available.

The memory DIMM is present, but has exceeded 
the number of failures threshold. It is 
deconfigured by the system and is currently 
unavailable.

The memory DIMM is present and available. It is 
configured by the user through the Service 
Processor menus.

The memory DIMM is present, but unavailable. It 
has been deconfigured by the user through the 
Service Processor menus.

The following is an example of the Language Selection Menu.

Note: Your ASCII terminal must support the ISO-8859 character set in order 
to properly display languages other than English. This menu allows selecting 
languages into which Service Processor and System Firmware menus and 
messages are displayed.

The Following is an example of a Call-In/Call-Out Setup Menu.

LANGUAGE SELECTION MENU

1. English
2. Francais
3. Deutsch
4. Italiano
5. Espanol
6. Svenska

98. Return to Previous Menu
99. Exit from Menus

1>