Справочник Пользователя для IBM 1483

1) Ensure that the system control unit is powered on and operational.

2) Turn the Power On/Off switch to 

 .

3) Set the Power-On/Off switch to 

On ( | )

 while simultaneously holding down the

space bar. After a few seconds, an alarm sounds.

4) Continue to hold the space bar down until a screen like the one in Figure 2-2, below,

is displayed. You may need to adjust the Brightness or Contrast control.

5) If the display station is designated to operate with settings other than the default

modes, see “Offline Test Menu” on Page 3- 5 for a description of the Offline Setup
menus to change the modes. Obtain the settings designated for the display station
from the system operator. The controller to which the display station attaches
must be configured to support the settings selected. When the display station is set
correctly, it is ready to go online. Press the Reset key to display the cursor in the
upper left corner of the screen and the operator status row at the bottom.

6) If the screen does not have the cursor in the upper left corner and the operator status

row at the bottom, see Chapter 7, “Problem Determination and Maintenance.”

7) Installation of the display station is now complete. Certain settings may be changed

while online. See  Figure 3-11, “Online Screen Menu”  for further information.