Справочник Пользователя для Acer Altos G710
3 System upgrade
46
(2) Locate and attach the following cables clamped on the side of
the chassis to their corresponding connectors on the SCSI
backplane:
backplane:
Important: If a four-bay hot-plug SCSI HDD cage is already
installed in the top HDD bay, you must block the J1 jumper. Set
pins 1 and 2 to close.
installed in the top HDD bay, you must block the J1 jumper. Set
pins 1 and 2 to close.
(a) SCSI data cable
(b) SCSI HDD power cable
(c) SCSI HDD management cable
(3) Tighten the four thumbscrews to secure it to the chassis.
4
Observe the post-installation instructions described on page 40.
Important: When you are detaching the hot-plug cage from the
chassis, make sure to first remove all hard disks from their carriers.
For instructions, refer to the succeeding section.
chassis, make sure to first remove all hard disks from their carriers.
For instructions, refer to the succeeding section.
5
Change the RAID configuration of your hard disk. For details on
how to change the RAID configuration of your hard disk, go to
“Appendix C: SCSI RAID configuration” on page 157.
how to change the RAID configuration of your hard disk, go to
“Appendix C: SCSI RAID configuration” on page 157.