Справочник Пользователя для Dukane 403-575-00

If Time has been enabled in the Static Hold Method, the 

actuator motion will stop at the end of the weld cycle for 

the programmed interval (Hold Dwell Time). When the 

interval is ended, the actuator motion changes so that it 

goes upward and travels to the Home position.

This unique feature allows for superior consistency on 

overall part height. This is unlike a pneumatic press that 

continues to compress the part during the hold phase. 

In addition, Static Hold can contribute to stronger weld 

bonds. See Figure 4-21 below.

 

iQ Explorer, Process Settings> Post Weld > Static Hold Method 

 Step 15 - Test the Acoustic Stack

Run a test of the acoustic stack. 

Please go to Section 5 of this User's Manual, System Op-

erational Testing, where the system test procedures are 

outlined.