Справочник Пользователя для Dukane 403-575-00

Pneumatic Step 9 - Process Settings > Pressure 

 

iQ Explorer > Process Settings > Post Weld > Pressure

For systems equipped with the Electronic Pressure 

Regulator option, weld pressure parameters need to be 

programmed in this section of the Process Settings 

page. See Figure 4-34.
Downstroke

 - This is the approach pressure before 

Trigger. For a basic setup, program a value here equal to 

Pressure 1.
Weld Pressure 1

 - Program a pressure value based 

on the force requirement suggested in the Initial Weld 

Force chart. See Table 4-I and Figure 4-35

.

Downstroke pressure must be pro-

grammed so that enough force will be 

available to achieve the programmed 

Trigger Force. If there is not enough 

downstroke pressure, it may cause the 

system to fault at Max Trigger Time.

 

Suggested Initial Weld Force