Справочник Пользователя для Dukane 403-575-00

Part 

detected before reach

-

ing start sensing distance.

Force in excess of 50 lb (220 N) was  detected before reaching Sensing Start  Distance.

1. Sensing Start Distance is too large. 2. Part(s) not properly loaded.

1. Decrease Sensing Start Distance. 2. Check part placement.

Press down travel limit  exceeded!

Lower travel limit switch activated.

Press moved sufficiently far down to  activate lower limit switch.

1. Lower bottom stop position. 2. Decrease weld or hold depth.

Servo actuator temperature  limit exceeded!

Servo actuator is too hot.

1. W

elder duty cycle is too large.

2. W

eld/hold times or forces are too 

large. 3. 

Thruster fan not working.

4. Servo actuator or amplifier is dam

-

aged.

1. Reduce cycle rate. 2. Change setup to reduce weld/hold forces or  decrease weld duration. 3. Check if fan is obstructed; contact DUKANE  service for replacement. 4. Contact DUKANE service.

Error detected at servo  press. OR Servo controller error!

One or more of servo-related error(s)  has occurred. 

This message is accom

-

panied by one of the following error  types displayed in the Status area: Amplifier Error Checksum Error Command Error Down T

ravel 

Limit

Force Duration Exceeded Position Error Servo Error Trigger < Sensing start Distance Up T

ravel 

Limit

See specific error type below

.

See specific error type below

.

Amplifier Error

Error occurred with servo amplifier

.

Faulty wiring or damaged amplifier

.

1. Restart press system. 2. Contact DUKANE service.

Checksum Error

Servo controller hardware error

.

Problem with servo controller hardware.

1. Restart press system. 2. Contact DUKANE service.

Command Error

Servo controller program error

.

Problem with servo controller hardware.

1. Restart press system. 2. Contact DUKANE service.

Down T

ravel 

Limit

Lower travel limit switch activated.

Press moved sufficiently far down to  activate lower limit switch.

1. Lower bottom stop position. 2. Decrease weld/hold depth.

Force Duration Exceeded

While in 

Teach mode, time allowed for 

press to produce moderate/large forces  was exceeded.

Moderate/large press force was being  applied for an extended period of time,  resulting in servo amplifier being auto

-

matically powered of

f.

Reduce force and/or amount of time force is  applied while in 

Teach mode.

 Page 1 of 2

  Error Messages, Servo-related