Справочник Пользователя для American Power Conversion 100 VAC
1
990-7096 Rev. 2
C
HAPTER
1: S
AFETY
I
NFORMATION
This Safety Guide contains important instructions that should be followed during installation and
maintenance of the APC equipment and batteries. It is intended for APC customers who setup,
install, relocate, or maintain APC equipment.
maintenance of the APC equipment and batteries. It is intended for APC customers who setup,
install, relocate, or maintain APC equipment.
Conventions Used in this Manual
This section defines the symbols used throughout this manual. Carefully read all information
boxes and abide by the instructions.
boxes and abide by the instructions.
The WARNING sign denotes a serious hazard. It calls attention to a
procedure, practice, condition, or the like, which, if not correctly
performed or adhered to, could result in injury to personnel.
procedure, practice, condition, or the like, which, if not correctly
performed or adhered to, could result in injury to personnel.
The CAUTION sign denotes a hazard. It calls attention to an operating
procedure, practice, or the like, which, if not correctly performed or
adhered to, could result in damage to or destruction of all or part of the
product.
procedure, practice, or the like, which, if not correctly performed or
adhered to, could result in damage to or destruction of all or part of the
product.
The NOTE sign denotes important information. It calls attention to a procedure,
practice, condition, or the like, which is essential to highlight.
practice, condition, or the like, which is essential to highlight.
Handling Safety
• Be careful. Do not lift heavy loads without assistance.
18 – 32 kg (40 – 70 lb.)
• This equipment is intended for installation in a temperature-controlled indoor area (see the
Specifications at the APC web site for exact temperature range), free of conductive
contaminants.
contaminants.
Electrical Safety
• To reduce the risk of fire, connect only to a circuit provided with a 20 A maximum branch
circuit overcurrent protection in accordance with the National Electrical Code ANSI/NFPA.
• Do not work alone under hazardous conditions.
• Check that the power cord(s), plug(s), and sockets are in good condition.
• Check that the power cord(s), plug(s), and sockets are in good condition.