Справочник Пользователя для AEG Protect 1.150

 
 

37 

If the battery cubicle is used in connection with the 
PROTECT 1.1.50 or PROTECT 1.200, the strain relief is 
implemented with clamps. 
The battery system can now be activated. To do this, insert the 
two fuses ‡.  
As the last step, fasten each cover that was initially removed. 

 

Fig.: PROTECT 1.BP20 in connection with the PROTECT 1.100

 

i

 

PROTECT 1.100 & 1.BP20: When connecting the
battery connection cable, make sure that the plugs
are inserted quickly and firmly in the battery
connectors. 

Prepare further PROTECT 1.BP20 battery cubicles as 
described above and then connect them to the terminals ˆ (X2 
and X3) of the previously installed battery cubicle with the 
enclosed battery connection cables. Observe the correct 
polarity "+" and "-" as well as an earth-fault- and short-circuit-
proof routing during connection. 

After completing the connection work, fasten the connection 
terminal cover again. At the final installation site, block the 
cubicles against slipping.