Справочник Пользователя для Infortrend A16E-G2130-4

EonStor A16E-G2130-4 Installation and Hardware Reference Manual  

 

2.  A BBU module has been charged for over twelve (12) hours. A timer is embedded 

with the charger. When this occurs, the charger will enter a timer fault state. The 

fault condition usually occurs with a brand new BBU or with a totally discharged 

BBU. Charging will resume automatically if you remove and re-install the BBU 

module. 

 

  Install or replace the BBU with BBUs supplied by your EonStor vendors only. 

Use of battery cells provided otherwise will void our warranty. 

  Always dispose of a replaced battery in an ecologically responsible manner. 

Dispose of used BBUs at authorized battery disposal sites only. 

  Do not use nor leave the BBU near a heat source. Heat can melt the insulation 

and damage other safety features of battery cells, possibly will cause acid leak 

and result in flames or explosion. 

  Do not immerse the BBU in water nor allow it to get wet. Its protective features 

can be damaged. Abnormal chemical reactions may occur, possibly cause 

functional defects, acid leak, and other hazardous results. 

  Do not disassemble or modify the BBU. If disassembled, the BBU could leak 

acid, overheat, emit smoke, burst and/or ignite. 

  Do not pierce the BBU with a sharp object, strike it with a hammer, step on it, or 

throw it. These actions could damage or deform it and internal short-circuiting 

can occur, possibly cause functional defects, acid leak, and other hazardous 

results. 

  If a BBU leaks, gives off a bad odor, generates heat, becomes discolored or 

deformed, or in any way appears abnormal during use, recharging or storage, 

immediately remove it from the subsystem and stop using it. If this is discovered 

when you first use the BBU, return it to Infortrend or your subsystem vendor. 

 

5-10 

Replacing a Faulty BBU