Справочник Пользователя для Mitsubishi Electronics 700 Series

When a basic instruction is used, an operation error will occur in the following
case.
(a) If any error described in the description of the corresponding instruction

occurs.

If an operation error occurred at execution of a basic instruction, the error flag
turns on and the error step number is stored into the error step storage register.

1) D9011 stores the step number of the instruction where an operation error occurred

when M9011 turned from OFF to ON. Therefore, D9011 data does not change if
M9011 remains on.

2) To reset M9011 and D9011, program as shown below.

Fig 3.28 Special Relay and Register Resetting Ladder

3) Whether sequence processing will be stopped or continued at occurrence of an

operation error can be selected by built-in PLC function parameter setting. Refer to
page 94 for details.

Error flag

M9010 ... Turns on at an operation error and turns off if the next basic 

instruction is normal.

M9011.... Turns on at the first operation error.

Error step 
storage register

D9010.... Stores the first step number of the instruction where an operation 

error occurred.

D9011 .... Stores the first step number of the instruction where an operation 

error occurred first.

M50 to M65 are the targets, but actual 
setting range is M0 to M63, and error 
occurs since M64 and M65 do not exist.

Resets (turns off) M9011.

Resets D9011.
(Clears D9011 to 0.)

Reset command

Reset command