Справочник Пользователя для Philips PXG10
PROBLEM
• CHECK
NO PICTURE AND NO SOUND.
• Projector power cord is not plugged into the wall outlet.
• The bottom filter cover is not securely installed.
• Selected input is wrong. (See pages 14)
• Cables improperly connected to rear panel of the projector.
• The bottom filter cover is not securely installed.
• Selected input is wrong. (See pages 14)
• Cables improperly connected to rear panel of the projector.
(See pages 11-13)
• Remote control batteries have run down. (See page 9)
SOUND IS HEARD BUT NO PICTURE APPEARS
• Cables improperly connected to rear panel of the projector.
(See pages 11-13)
•“Contrast” and “Bright” adjustments are set to minimum
position. (See page 18)
• On-screen Display (“AV-MUTE”) is turned off and AV-Mute
function is turned on, creating a black image. (See page 22)
PICTURE APPEARS BUT NO SOUND IS HEARD
• Cables improperly connected to rear panel of the projector.
(See pages 11-13)
• Volume is set to minimum. (See page 14)
COLOUR IS FADED OR POOR
•“Color” and “Tint” adjustments are not correct.
(See page 18)
COLOUR IS DISTORTED (EXCEPT FOR VIDEO MODE)
• Change the input signal type. (See page 14)
PICTURE IS BLURRED
• Adjust the focus. (See page 9)
• Projection distance is too long or too short to allow for
• Projection distance is too long or too short to allow for
proper focus. (See page 8)
PICTURE NOISE APPEARS
• Adjust the phase setting. (See page 17)
• Noise may appear when used with certain computers.
• Noise may appear when used with certain computers.
480P IMAGES DO NOT APPEAR
• Set the resolution mode to 480P. (See page 16)
AN UNUSUAL SOUND IS OCCASIONALLY HEARD FROM
THE CABINET
THE CABINET
• If the picture is normal, the sound is due to cabinet
shrinkage caused by temperature changes.
This will not affect operation or performance.
This will not affect operation or performance.
MAINTENANCE INDICATOR LIGHTS UP
• Refer to “Lamp/Maintenance Indicators” on page 25.
LENS COMES OFF
• Align the mark on the lens with the corresponding mark on
the projector, push the lens firmly in place, and rotate to the
right.
right.
28
10. TROUBLESHOOTING
English
If a fault occurs, first check the points listed below before taking the projector for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service organisation.
WARNING
Under no circumstances should you try to repair the projector yourself as this could invalidate the warranty.