Справочник Пользователя для Mitsubishi Electronics XD95U

EN-32

(default setting/value)

(default setting/value)

 (Off)

Corrects the projected picture’s color when the projection surface is not 
white. See 

 for details.

(Auto)

There are four options to set the image's aspect ratio depending on your 
input signal source. See 

 for 

details.

(0)

Corrects any keystoning of the image. See 

 for details.

(0)

Displays the position adjustment page. To move the projected image, use 
the directional arrow keys. The values shown on the lower position of the 
page change with every key press you made until they reach their 
maximum or minimum.

(depends on the selected input signal)

Adjusts the clock phase to reduce image distortion.

(0)

Adjusts the horizontal width of the image.

(1.0X)

Magnifies or reduces the projected image. See 

 for details.

(PC Source: Photo;
Video source: Standard)

Pre-defined picture modes are provided so you can optimize your 
projector image set-up to suit your program type. See 

 for details.

(Photo)

Selects a picture mode that most suits your need for the image quality and 
further fine-tune the image based on the selections listed on the same 
page below. See 

 for details.

(50)

Adjusts the brightness of the image. See 

 for details.

(0)

Adjusts the degree of difference between dark and light in the image. See 

 for details.

(0)

Adjusts the color saturation level -- the amount of each color in a video 
image. See 

 for details.

(0)

Adjusts the red and green color tones of the image. See 

 for details.

(15)

Adjusts the image to make it look sharper or softer. See 

 for details.

(On)

Adjusts white peaking while maintaining correct color presentation. See 

 for details.

(T1)

See 

 for details.

See 

 for details.

Saves the settings made for User 1 or User 2 mode.