Справочник Пользователя для Mitsubishi Electronics XD90U
EN-22
Basic Operation
Start up
If the projector is still hot from previous activity, it will run the cooling fan for approximately 90
seconds before energizing the lamp.
seconds before energizing the lamp.
4.
If you are prompted for a password, press the arrow buttons to select the four
password digits, then press the AUTO button. For information about the password
function, refer to
password digits, then press the AUTO button. For information about the password
function, refer to
5.
Switch all of the connected equipment on.
6.
The current input source being scanned displays in the upper part of a dialog on the
screen. The scan will continue until signal from the input source is detected.
screen. The scan will continue until signal from the input source is detected.
If the Auto Off function (See
for details) is activated, the projector
will turn off automatically if no input signal is detected from the selected source after the
period of time as set by the Auto Off function.
period of time as set by the Auto Off function.
1.
Plug the power cord into the projector and
into a wall socket. Turn on the wall socket
switch (where fitted). Check that the
POWER indicator on the projector lights
orange after power has been applied.
into a wall socket. Turn on the wall socket
switch (where fitted). Check that the
POWER indicator on the projector lights
orange after power has been applied.
2.
Slide open the lens cover. If it is left closed,
it could become deformed due to heat.
it could become deformed due to heat.
3.
Press the Power button on the remote
control or projector to start the unit. The
POWER indicator light flashes green and
stays green when the unit is on.
control or projector to start the unit. The
POWER indicator light flashes green and
stays green when the unit is on.
The start up procedure takes about 30
seconds after pressing the Power button In
the later stage of start up, a default XD90U
logo is projected.
seconds after pressing the Power button In
the later stage of start up, a default XD90U
logo is projected.