Справочник Пользователя для Mitsubishi Electronics WL6700U

EN-39

This projector includes a terminal cover with Anti-Theft 
Alarm device. Once the terminal cover is installed, its 
Anti-Theft Alarm device will detect vibration caused by 
the projector being moved and emit an alarm. 
•  Mitsubishi assumes no responsibility or liability for 

theft or other damages. 

1.  Open the battery cover of the theft warning device. 

2.  Check the (+) and (-) ends of the battery, and insert 

it from the (-) end fi rst.

Battery cover

Power switch

ON

•  Inserting the battery from the (+) end makes 

it diffi cult to fi t the (-) end into the coil spring. 
Forcing in the battery in such a position may 
shred the outside label, causing a short circuit 
and overheating. 

•  See page 6 for information on how to handle 

batteries. 

3.  Close the battery cover.

Safety pin hole

Safety pin

Screws

4.  Insert the included safety pin into the safety pin 

hole. 
•  If the safety pin is not inserted, the vibrations 

and shocks of normal use may cause the alarm 
to sound. 

5.  Turn the power switch ON.

1.  Insert the four tabs on the terminal cover into the 

holes on the projector’s side. 

2.  Slide the terminal cover toward the back of the 

projector. 

Tabs

3.  Tighten the three screws that keep the terminal 

cover in place. 

4.  Install the projector in a specifi ed location. 

5.  Press the battery level check button until you hear 

a buzzer sound.    

6.  Remove the safety pin. 

 

The anti-theft alarm device is now in standby. 

•  This package includes a sticker which shows 

that the anti-theft alarm device is active. Visible 
placement of this sticker is recommended.

•  To temporarily halt the anti-theft alarm device, 

insert the safety pin. 

•  Vibrations will not cause the alarm to sound for 

several seconds after the power switch is turned 
ON.  

•  Vibrations will not cause the alarm to sound for 

several seconds after the safety pin is removed. 

•  Vibrations and shocks from earthquakes may 

cause the alarm to sound. In such situations, 
insert the safety pin to halt the alarm.

•  Batteries may come loose during transportation. 

Please remove them beforehand.  

Use a pointed object to push the battery level check 
button. 

Battery level 
check button

•  A buzzer will sound while the button is being 

pushed. If there is no buzzer sound, then batteries 
need to be changed.  

•  Sounding the buzzer for a long time will consume 

battery power. 

1.  Insert the safety pin into the safety pin hole. 

2.  Loosen the three screws that keep the terminal 

cover in place.

3.  Slide the terminal cover toward the front of the 

projector. 

4.  Pull the terminal cover toward you and remove it. 

•  Attention must be paid when removing the 

terminal cover as there could be foreign objects 
inside.

•  Removal of dust found inside the terminal cover 

is recommended when changing batteries. 

5.  Open the battery cover and remove the old 

batteries.

6.  Check the (+) and (-) ends of the new battery, and 

insert it from the (-) end fi rst. 
•  Use alkaline AA batteries. 
•  Standard battery life is approx. six months (when 

using alkaline dry cell batteries). Please check 
the battery level and change batteries regularly. 

7.  Close the battery cover.