Справочник Пользователя для Mitsubishi Electronics LVP-XD10U
English 7
Operation
Turn On/Off Procedure
A
Power on
Press the Standby/On key for 2 seconds to turn on the lamp. The LED will blink orange
during the warm up and will then light solid green.
during the warm up and will then light solid green.
z
“INPUT SIGNAL DETECTED, ACTIVATING AUTO IMAGE” will be displayed on the screen after
the projector has identified the input signal;
the projector has identified the input signal;
z
“SEARCHING” message will be displayed on the screen if there is no signal input;
z
“SYNC IS OUT OF RANGE” message will be displayed on the screen if the horizontal frequency of
the input signal exceeds the range of the projector.
the input signal exceeds the range of the projector.
B
Standby
Press the Standby/On key for 2 seconds to turn off the lamp. The LED will then blink
green
and the lamp will shut down, but the fan will continue to run for about 1 minute to cool the
lamp. After the fan stops, the LED will turn to a light solid orange.
lamp. After the fan stops, the LED will turn to a light solid orange.
*Lamp Protection Procedure: If you try to turn on the lamp again while the LED is blinking, the projector
will ignore the command until it has cooled down for one minute.
will ignore the command until it has cooled down for one minute.
External Control
A Control
Pad
Hotkey
Figure 10 Hotkey control pad
REMOTE
R
ECEIVER
M
ENU
-K
EYSTONE
+K
EYSTONE
A
UTO
L
AMP
S
TATUS
I
NDICATOR
STANDBY
/O
N
I
NDICATOR
S
TANDBY
/O
N
3