Справочник Пользователя для Mitsubishi Electronics ES100

EN - 26

POWER

STATUS

POWER

Steady 

red

Steady 

green

Steady 

green

STATUS

Off

Blinking 

green

Steady 

green

CONDITION

Stand-by

Lamp stand-by (about 1 minute)

The power is on. (Normal condition)

NOTE

The POWER button cannot be used to
switch between on and off.

POWER

Steady 

green

or

Steady red

Steady red

Steady 

green

Steady red

Steady red

Blinking 

green/red

Blinking 

green/red

STATUS

Blinking orange

Blinking green

Blinking green/red

Blinking red

Steady red

Off

Steady

or

Blinking

CONDITION

Abnormal temperature
•  The ventilation grilles is clogged with dust or dirt.

•  The room temperature is high.

The protection circuit is working or the lamp is in an
abnormal condition. 

The lamp operation time exceeds the time elapsed until the 
lamp shutdown notice while the power is on. (See page 22.)

The lamp operation time exceeds the time elapsed until the 
lamp shutdown notice while the power is off. (See page 22.)

The lamp operation time exceeds the time elapsed until the 
lamp shutdown. (See page 22.)

The lamp cover isn’t closed. 

Abnormal.

POSSIBLE SOLUTION

•  Clean the ventilation grilles.
•  Relocate the projector to a cooler place.

•  Wait until the STATUS indicator goes out, 

then press the POWER button.

•  If the above solution is not effective, replace 

the lamp.

Replace the lamp.
Change with a new lamp if this problem recurs.

Close the cover correctly.

Contact your dealer.

This projector has two indicators, each of which shows the operation condition of the projector. 
The following offer solutions to possible problems. If these problem persist, turn the projector off and consult your 
dealer. 

POWER indicator

STATUS indicator