Справочник Пользователя для Compaq 410CX 486 DX2/50 MHZ 350 MB 4 MB 8.4
Chapter 5. Error Messages and Codes
Introduction
This chapter provides tables covering possible errors messages for the
Power-On Self-Test (POST) and the Computer Checkup (TEST) diagnostics.
Power-On Self-Test (POST) and the Computer Checkup (TEST) diagnostics.
Chapter 5.1 Power-On Self-Test (POST)
POST error messages occur when problems are discovered during POST.
Table
5-1 lists visual error messages for POST, audible (beep) error messages,
probable causes, and recommended actions.
probable causes, and recommended actions.
Table 5-1. Power-On Self-Test Messages
===========================================================================
Message
===========================================================================
Message
Beeps
Probable Cause
Recommended Action
===========================================================================
101 - ROM
101 - ROM
1 Long,
System ROM
1. Inspect the ROM
Error
1 Short
checksum
placement.
2. Replace the ROM.
3. Flash the ROM.
4. Replace the system board.
3. Flash the ROM.
4. Replace the system board.
---------------------------------------------------------------------------
101 - I/0
101 - I/0
None
Option ROM
1. Inspect the ROM
ROM Error
checksum
placement.
2. Verify the correct ROM.
3. Replace the ROM.
3. Replace the ROM.
---------------------------------------------------------------------------
102 - System
102 - System
None
DMA, timers,
1. Replace the processor
Board
etc. Unsupported
board.
Failure
processor
2. Replace the system board.
upgrade installed
---------------------------------------------------------------------------
162 - System
162 - System
2 Short
No diskette drive
1. Run Computer Setup.
Options
or mismatch in
2. Check diskette cable.
Error
drive type
3. Check diskette drive.
---------------------------------------------------------------------------
162 - System
162 - System
2 Short
Configuration
Run Computer Setup.
Options Not
incorrect
Set
---------------------------------------------------------------------------
163 - Time &
---------------------------------------------------------------------------
163 - Time &
2 Short
Invalid time or
Run Computer Setup.
Date Not Set
date in
configuration
memory
configuration
memory
---------------------------------------------------------------------------
164 - Memory
164 - Memory
2 Short
Configuration
The following steps apply to
Increase
memory incorrect
164 Memory Increase Detected
Detected
and 164 Memory Decrease
Detected error messages:
Detected error messages:
164 - Memory
2 Short
Configuration
Decrease
memory incorrect
1. Autosetup will correct.
Detected
2. Verify that memory board
is installed correctly.
3. Replace memory board.
4. Replace system board.
4. Replace system board.