Справочник Пользователя для HP (Hewlett-Packard) HP Kayak XM600
Installing and Replacing Hardware Parts in Your PC Workstation
Removing and Replacing the Cover and Front Bezel
3
Removing and Replacing the Cover and Front Bezel
Removing the
Cover
Cover
For your own safety, it is recommended that you first read the warning
notices on in the Introductory Section.
notices on in the Introductory Section.
1
Switch off the display and computer. Disconnect all power cables and
any LAN or telecommunications cables.
any LAN or telecommunications cables.
2
Unscrew the two thumb screws located at the back of the PC
Workstation.
Workstation.
3
Standing at the back of the PC Workstation, slide the cover towards you
until it clicks into place.
until it clicks into place.
4
Tilt the cover sidewards, then lift off the PC Workstation chassis.
Removing the
Front Bezel
Front Bezel
5
If required, remove the front bezel which is divided into two sections:
•
The upper bezel (blue) gives access to three 5.25-inch shelves and two
3.5-inch shelves.
3.5-inch shelves.
•
The lower bezel (grey) gives access to the control panel. To access the
lower bezel, you must first remove the upper bezel.
lower bezel, you must first remove the upper bezel.
➍
Chapter2.fm Page 3 Wednesday, December 8, 1999 6:13 PM