Справочник Пользователя для Patton electronic 1214
Connecting the Line Interface
16
CopperLink 1214 User Manual
2 • Installation
Connecting the Line Interface
CAUTION
The interconnecting cables shall be acceptable for external use
and shall be rated for the proper application with respect to volt-
age, current, anticipated temperature, flammability, and
mechanical serviceability.
and shall be rated for the proper application with respect to volt-
age, current, anticipated temperature, flammability, and
mechanical serviceability.
The CL1214 supports communication between two peer Ethernet LAN sites over a distance of up to 10,000 ft
(3 km) over 24 AWG (0.5 mm) twisted-pair wire, Cat5+, or 75-ohm BNC.
(3 km) over 24 AWG (0.5 mm) twisted-pair wire, Cat5+, or 75-ohm BNC.
Note
Actual distance and link performance may vary depending on the environ-
ment and type/gauge of wire used.
ment and type/gauge of wire used.
Follow the steps below to connect the CL1214 CopperLink Interfaces.
Note
The CL1214 units work in pairs. One of the units must be configured as a
(L) Local unit, and the other unit must be configured as a (R) Remote unit.
(L) Local unit, and the other unit must be configured as a (R) Remote unit.
Connecting the Line Interface for CL1214/EUI or CL1214/TB
1. To function properly, the two CL1214s must be connected together using twisted-pair, unconditioned,
1. To function properly, the two CL1214s must be connected together using twisted-pair, unconditioned,
dry, metal wire, between 19 (0.9mm) and 26 AWG (0.4mm). Leased circuits that run through signal
equalization equipment are not acceptable.
equalization equipment are not acceptable.
2. The CL1214 is equipped with an RJ-45 interface jack (
) or terminal block (
that can be used on the CopperLink interface. The CopperLink interface is a two-wire interface. Observe
the signal/pin relationships on the CL1214’s CopperLink interface jack.
the signal/pin relationships on the CL1214’s CopperLink interface jack.
The RJ-45 connector on the CL1214’s twisted pair interface is polarity insensitive and is wired for a two-wire
interface. The signal/pin relationship is shown in
interface. The signal/pin relationship is shown in
.
1 (no connection)
2 (no connection)
3 (no connection)
4 (RING)
5 (TIP)
6 (no connection)
7 (no connection)
8 (no connection)
1
2
3
4
5
6
7
8
2
3
4
5
6
7
8
Figure 3. CL1214 (RJ-45) twisted pair line interface.