Справочник Пользователя для D-Link DFE-916X
Dual-Speed Stackable Hubs User’s Guide
Unpacking and Setup
11
For more information about crossover connection, see the section enti-
tled Crossover Cables section on page 30.
tled Crossover Cables section on page 30.
♦
Uplink Port
The Uplink port is an MDI-II port, which means you can connect the
hub (or hub stack) to another device with MDI-X ports using an ordi-
nary straight-through cable, making a crossover cable unnecessary.
hub (or hub stack) to another device with MDI-X ports using an ordi-
nary straight-through cable, making a crossover cable unnecessary.
Port 1 and the Uplink port are really the same port, except that their
pinouts are different. Do not use both Port 1 and the Uplink port at
the same time.
pinouts are different. Do not use both Port 1 and the Uplink port at
the same time.
Rear Panel
♦
Module Slots
Used to install module options for various kinds of additional connec-
tions, as well as the DFE-260S 10Mbps/100Mbps bridge module. (In
the DFE-916x, the module slot is already occupied by the switching
module which is standard on these models.)
tions, as well as the DFE-260S 10Mbps/100Mbps bridge module. (In
the DFE-916x, the module slot is already occupied by the switching
module which is standard on these models.)
♦
Daisy-Chain IN Port
When cascading a set of D-Link’s stackable dual-speed hubs, this port
should be connected to the Daisy-Chain OUT port of the previous hub
in the stack (usually placed immediately above it). A cascade of five
should be connected to the Daisy-Chain OUT port of the previous hub
in the stack (usually placed immediately above it). A cascade of five