Справочник Пользователя для DELL 9.8(0.0)

1.

To enable VRRP globally, verify that you are logged in to CONFIGURATION mode. 

2.

Enter the vrrp-group command then enter the VRRP group ID. The prompt changes to include 

(conf-if-interface-type-slot/port-vrid-vrrp-group-id). 

u-Boot Mode

To enable u-Boot mode, press any key when the following line appears on the console during a system 
boot: Hit any key to stop autoboot:. The prompt changes to include ( =>). For more information, 
refer to 

.

NOTE: You cannot use the Tab key to complete commands in u-Boot mode.

UPLINK STATE GROUP Mode

To enable and configure an uplink-state group, use UPLINK STATE GROUP mode. For more information, 
refer to 

.

To enter UPLINK STATE GROUP mode:

1.

Verify that you are logged in to CONFIGURATION mode. 

2.

Enter the uplink-state-group command then the group ID number. The prompt changes to 

include (conf-uplink-state-group-groupID). 

CLI Basics

63